Bissell 82H5 Operation, Handle position, Powerfoot height adjustment, Transporting cleaner

Assembly

Attach vacuum hose and tools continued

7.Place the TurboBrush in the bracket by aligning the bottom of the bracket with the opening of the brush roll and snap the TurboBrush into place.

Operation

Handle position

Press the handle release pedal with your foot to place your BISSELL PowerForce Turbo Bagless into one of three cleaning positions.

1.Upright- For storage and above floor cleaning with special tools.

2.Normal Cleaning- Press handle release pedal once. Use for most household floor cleaning tasks.

3.Low Cleaning- With the vacuum in normal cleaning position, press handle release pedal again. Use for reaching under low furniture such as tables, chairs and beds.

Powerfoot height adjustment

The powerfoot/rotating floor brush on your BISSELL PowerForce Turbo Bagless can be adjusted to clean several floor surfaces.

NOTE: For optimal cleaning performance, adjust to the lowest practical setting. If your cleaner is difficult to push, adjust to the next higher setting.

1.Place handle in upright position.

2.Turn height adjustment knob to desired setting.

Lowest Setting - For bare floors.

Medium Settings - For short and medium pile carpets.

Highest Setting - For plush pile carpets.

3.Place the handle into the normal cleaning position and the powerfoot will adjust to the setting chosen.

NOTE: You may also adjust the setting while in the normal cleaning position.

Transporting cleaner

1.To move your cleaner from room to room, put the handle in the upright position, tilt the cleaner back on its rear wheels and push forward.

2.The cleaner can also be moved by using the carrying handle on the back.

16 w w w . b i s s e l l . c o m

1

2

3

CAUTION:

Before using your vacuum, make sure that the dirt container is in locked position and that all filters (inner circular, outer circular, pre-motor and post-motor) are in place. Do not operate your vacuum without these filters.

ATTENTION:

Some Berber carpets have a tendency to fuzz with wear. Repeated strokes in the same area may aggravate this condition. Consider setting your cleaner on a higher than normal setting for this type of carpet.

Tip:

Before cleaning under low furniture, check area first for objects that might harm the unit or block the vacuum hose.

Tip:

	Your vacuum features
	a Quick Release cord
	wrap. To remove the
	power cord quickly
	and easily, rotate
	the upper cord wrap
Carrying	towards the floor, and
	slip power cord from
Handle
	upper and lower
	cord wraps.

ug110-4049_82H5_1008.indd 6

10/14/08 2:39:57 PM