BIXOLON SRP-770II user manual Self-Test

SRP-770II

4. Self-Test

The self-test checks whether the printer has any problems.

(Users cannot perform this procedure if using the printer’s label peel-off option.) If the printer does not function properly, contact an authorized dealer.

The self-test checks the following;

1)Make sure that the paper roll has been installed properly.

2)Turn on the power while holding down the FEED button. The self-test begins.

3)The self-test prints the current printer status, which provides the control ROM version and the DIP switch settings.

4)After the self-test results are printed out:

-No button input within 2 seconds: Normal Print Mode

-Button pressed once within 2 seconds: Hex Dump Mode

-Button pressed twice within 2 seconds: Line Print Mode

*The ESC-POS command set is used in Line Print Mode. Received data is printed in sequence similar to a receipt printer.

*If it is necessary to set the line mode as the default mode when power is on, please turn on the dip switches 1-6 and 2-8 together.

ON

Rev. 1.14 - 14 -