90537965 BD Circ Saws 5/30/08 10:11 AM Page 12
NO
12 25
26
27
P
2726
Q
Assembly/Adjustment Set-Up
WARNING: TO REDUCE THE RISK OF INJURY, ALWAYS REMOVE BATTERY FROM SAW BEFORE ANY OF THE FOLLOWING ADJUSTMENT OPERATIONS.
CUTTING DEPTH ADJUSTMENT - FIGURES I & J
The depth of cut should be set according to the thickness of the workpiece.
•Loosen the depth adjustment knob or lever (14) to unlock the saw shoe (8). NOTE: Can be a knob or lever depending on model purchased.
•Move the saw shoe into the desired position. The corresponding depth of cut can be read from the scale (17).
•Tighten the knob or lever to lock the saw shoe in place.
•Set depth adjustment of saw such that one tooth (18) of the blade projects below the workpiece (19) as shown in figure J.
BEVEL ANGLE ADJUSTMENT - FIGURE K
This tool can be set to bevel angles between 0° and 50°.
•Loosen the bevel adjustment knob (13) to unlock the saw shoe.
•Move the saw shoe (8) into the desired position. The corresponding bevel angle can be read from the scale (20).
•Tighten the bevel adjustment knob (13) to lock the saw shoe in place.
12
