Black & Decker BDCS1806, 90537965, BDCS1807, BDCSL1806 Safety Warnings And Instructions Charging

90537965 BD Circ Saws 5/30/08 10:11 AM Page 7

For your convenience and safety, the following labels are on your laser. (BDCSL1806)

SAFETY WARNINGS AND INSTRUCTIONS: CHARGING

1.This manual contains important safety and operating instructions.

2.Before using battery charger, read all instructions and cautionary warnings on battery charger and product using battery.

CAUTION: To reduce the risk of injury, use charger only with this product. Batteries in other products may burst causing personal injury or damage.

3.Do not expose charger to rain or snow.

4.Use of an attachment not recommended may result in a risk of fire, electric shock, or injury to persons.

5.To reduce risk of damage to electric plug and cord, pull by plug rather than cord when disconnecting charger.

6.Make sure cord is located so that it will not be stepped on, tripped over, or otherwise subjected to damage or stress.

7.An extension cord should not be used unless absolutely necessary. Use of improper extension cord could result in a risk of fire, electric shock or electrocution.

a. Two-wire cords can be used with

2-wire or 3-wire extension cords. Only round jacketed extension cords should be used, and we recommend that they be listed by Underwriters Laboratories (U.L.). If the extension is to be used outside, the cord must be suitable for outdoor use. Any cord marked for outdoor use can also be used for indoor work. The letters "W" or "WA" on the cord jacket indicate that the cord is suitable for outdoor use.

b.An extension cord must have adequate wire size (AWG or American Wire Gauge) for safety, and to prevent loss of power and overheating. The smaller the gauge number of the wire, the greater the capacity of the cable; that is, 16 gauge has more capacity than 18 gauge. When using more than one extension to make up the total length, be sure each extension contains at least the minimum wire size for the total length.

8.Use only the specified charger when charging your tool. The use of any other charger could damage the tool or create a hazardous condition.

9.Use only one charger when charging.

10.Do not attempt to open the charger. There are no customer serviceable parts inside. Return to any authorized Black & Decker service center.

7