
NOTE: The cleaner the filter is, the better the product will perform.
• The dust bowl can also be washed in warm soapy water as shown in figure H. Ensure that it is dry before
• Never immerse the product in water. A damp cloth and soapy water should be used to clean the exterior of the motor section. Always ensure the product is completely dry before
RUN TIME
• When fully charged, the average effective usage times are between
• It may take several chargings before these times can be achieved.
Other Information
If the product does not work, check the following:
• The charger was correctly plugged in for recharge. (It feels slightly warm to the touch.)
• The charger cord is not damaged and is correctly attached to the base.
• The charger is plugged into a working electrical outlet.
ACCESSORIES
The performance of your appliance depends on the accessory used. Black & Decker accessories are engineered to high quality standards and are designed to enhance the performance of your appliance.
• Filter accessory number VF200SP.
Problem | Troubleshooting | Possible Solution | |
Possible Cause | |||
• Unit will not start. | • Battery not installed properly. | • Check battery installation. |
|
| • Battery not charged. | • Check battery charging | |
• Battery will not charge. | • Battery not inserted into charger. | requirements. | |
• Insert battery into charger | |||
| • Charger not plugged in. | until green LED appears. | |
| • Plug charger into a working | ||
|
| outlet. Refer to “Important | |
|
| Charging Notes” for more | |
|
| details. | |
|
| • Check current at receptacle | |
|
| by plugging in a lamp or other | |
|
| appliance. | |
|
| • Check to see if receptacle is | |
|
| connected to a light switch | |
|
| which turns power off when | |
| • Surrounding air temperature | you turn out the lights. | |
| • Move charger and tool to a | ||
| too hot or too cold. | surrounding air temperature | |
|
| of above 40 degree F(4,5°C) | |
|
| or below 105 degree F | |
|
| (+40,5°C). |
For assistance with your product, visit our website www.blackanddecker.com for the location of the service center nearest you or call the BLACK & DECKER help line at
Maintenance
Use only mild soap and damp cloth to clean the vac. Never let any liquid get inside the vac; never immerse any part of the vac into a liquid.
NOTE: Make sure the vacuum is completely dry before using it.
IMPORTANT: To assure product SAFETY and RELIABILITY, repairs, maintenance and adjustment (other than those listed in this manual) should be performed by authorized service centers or other qualified service organizations, always using identical replacement parts.
The RBRC™ Seal
The RBRC™ (Rechargeable Battery Recycling Corporation)
Seal on the
7