Black & Decker BDH1850SM Attaching a cleaning pad Fig. F, Removing a cleaning pad Fig. G

Attaching a cleaning pad - Fig. F

Replacement cleaning pads are available from your Black & Decker dealer (cat. no. SMP20).

• Place a micro-fiber cleaning pad (6) on the floor with the ‘hook & loop’ side facing up.

• Raise the steam mop off the resting mat (7) and press it down onto the cleaning pad. You are now ready to steam clean and sanitize your floor.

NOTICE: Always place the steam mop on the resting mat (7) with the handle tube (4) in the upright position when stationary and make sure the steam mop is turned off when not in use.

F

Removing a cleaning pad - Fig. G		G
	CAUTION: Always wear suitable shoes when
changing the cleaning pad on your steam mop. Do not
wear slippers or open-toed footwear.
•	Return the handle tube (4) to the upright position
•	and turn the steam mop ‘OFF’.
	Place the steam mop on the resting mat (7) and wait
•	until it cools down. (approximately five minutes)
	Place the front of your shoe onto the cleaning pad
•	removal tab (14) and press down firmly.
	Lift the steam mop up off the cleaning pad.
NOTICE: Always place the steam mop on the resting mat (7) with the handle (4) in the
upright position when stationary and make sure the steam mop is turned off when not in use.
Attaching the carpet glider - Fig. H
•	Place carpet glider on the floor.	H
•	Lightly press the steam mop with attached cleaning pad
	down onto the carpet glider (8) until it clicks into place.
NOTICE: Always place the steam mop on the
resting mat (7) with the handle tube (4) in the upright
position when stationary and make sure the steam mop
is turned off when not in use.
Removing the carpet glider
	CAUTION: Always wear suitable shoes when
changing the carpet glider on your steam mop. Do not
wear slippers or open-toed footwear.
•	Return the handle tube to the upright position and turn the steam mop ‘OFF’.
•	Place the steam mop on the resting mat and wait until it cools down. (approximately
•	five minutes)
	Place the front of your shoe onto the carpet glider removal tab (15) and press down firmly.
•	Lift the steam mop up off the carpet glider.

NOTICE: Always place the steam mop on the resting mat (7) with the handle (4) in the upright position when stationary and make sure the steam mop is turned off when not in use.

Fitting a scent pack - Fig. I		I1	I2
Return the handle (4) to the upright position and turn				29	30
		9
the steam mop ‘OFF’. Wait until the steam mop cools
down. (approximately five minutes).
•	Slide the Fresh Scent door release button (9), the
•	door will open.
	Place the Fresh Scent tab into the pocket (29) as
•	shown in figure I2.
	Close the door (30) py pushing it firmly down until an
	auidle click is heard.

NOTICE: Always place the steam mop on the resting

mat (7) with the handle (4) in the upright position when stationary and make sure the steam mop is turned off when not in use.

6