Black & Decker BDH1850SM

hand-heLd steaM cLeaner attachMents

notIce:

First remove the hand-held steam cleaner

from the steam body.

attachInG the hose or

VarIaBLe noZZLe - fig. J

• Press in the clips (17) on either side of the hose (16)

or variable nozzle.

• Align the two keys on the inside flange of the hose

or variable nozzle with the two slots adjacent to the

steam nozzle on the hand-held steam cleaner or hose.

• Firmly press the hose or variable nozzle onto the

steam nozzle (18) of the hand-held steam cleaner or

hose such that it is fully seated, and release the clips.

WarnInG: Inspect the seal on the steam

nozzle of the hose and handheld steam cleaner before

each use (figure k). If the seal is missing or

damaged contact your nearest authorized repair

agent. Do not use the appliance.

cautIon: Ensure that the hose and/or variable nozzle is securely fastened before

using the hand-held steam cleaner.

attachInG other accessorIes to the hose - fig. L

• For accessories other than the variable nozzle, align the lugs (19) on the hose with the recesses

on the accessory.

•

Press the accessory onto the hose and twist clockwise

until the accessory is fully seated and clicks into place.

reMoVInG other accessorIes

froM the hose

• For accessories other than the variable nozzle, twist

accessory counterclockwise then pull away from the hose.

reMoVInG the hose

• Press in the clips on either side of the hose and pull

away from the steam nozzle.

fILLInG the Water tank - fig. M

This Steam Mop incorporates an anti-calcium system to help prolong the life of the system.

notIce:

Fill the water tank with regular tap water.

notIce:

In areas of very hard water, the use of

de-ionized water is recommended.

WarnInG:

Do not over fill the tank. Use supplied

jug (22) to fill tank, and do not fill jug above indicated max line.

• Ensure that the appliance is switched off and the

power cord is disconnected from the power supply.

• Place the steam mop on the resting mat (7) with the

handle tube (4) in the upright position.

• Open the filler cap (21) by pulling down.

• Fill the supplied jug (22) with water to the max line, and then use jug to fill water tank (3)

• Close the filler cap.

notIce: Always empty the water tank after use.

oPeratIon

cautIon: for fLoor use onLy; do

not use the unIt uPsIde doWn.

sWItchInG on/off - fig. n

notIce:

When the steam mop is first turned on the

water reservoir will glow red. Once the steam mop is

ready to use the water reservoir will glow blue. It takes

approximately 15 seconds for the steam mop to heat up.

Seal