• Separate the nozzle section from the sprayer motor by pressing the release button on the motor housing as shown in figure N.
• Grasp the nozzle section and twist until it is
90 degrees to the housing, then pull straight out (figure O).
• If using water based material, clean the nozzle section by running water through pickup tube inlet as shown in figure P. If using oil based materials, clean pickup tube inlet with the appropriate cleaning solution. Repeat until sprayer is completely clean.
• Dry all parts thoroughly.
• Properly dispose of cleaning solution.
• Place a drop of household oil onto the metal ball in the check valve
(figure Q). IMPORTANT:Lubricating the ball in check valve, after cleanup, will help to prevent it from sticking which can clog the valve and prevent adequate flow of spray material.
NOTE: When reassembling, place metal ball end of check valve into sprayer.
•Reassemble sprayer (figure R). NOTE: The spray tip can only go in one way. The notch on the spray tip, shown in figure S must align with the recess in the threads of the sprayer.
N | O |
S |
10
