CLEANING
Be sure to use appropriate protective gear.
• UseWARNING:drop cloths during pouring, mixing, and viscosity testing of materials to be sprayed to protect your floors and anything else in the spraying area that you wish to remain untouched.
• Do not use materials with a flashpoint higher than 60°C ( 140°F) . Flashpoint is the temperature that a fluid can produce enough vapors to ignite (see coating supplier).
• Make sure clean up area is well ventilated and free of flammable vapors.
• Always spray outdoors when spraying cleaning solution through sprayer.
• Do not submerse power unit.
To begin cleaning:
• Unplug the cord from the power source.
• Unscrew the lid from the side of the canister and pour any remainingliquid back into the original container (figure I).
•Pour a small amount of the appropriate cleaning solution into the canister (figure J).
•Warm soapy water for water based materials
•Manufacturers recommended cleaning solution for oil based materials
•Replace the lid on the canister securely and vigorously shake the sprayer.
•Unscrew the lid from the side of the canister and properly dispose of cleaning solution.
•Refill the canister with a small amount of new cleaning solution (figure J). Screw lid securely on canister.
• Plug in the power cord.
• Spray the cleaning solution through the sprayer onto scrap material for 2 to 3 seconds (figure K).
• Unplug the cord from the power source.
• Remove the canister and unscrew the side lid. Remove the check valve, pickup tube and
•Unscrew the tip collar and remove the spray nozzle and spray tip (figure M). Clean all parts with the cleaning brush in the appropriate cleaning solution.
9
