•DO-Keep saw blade sharp.
•DO-Keep motor air slots free of chips and dirt.
•DO-Use blade guards at all times.
•DO-Keep hands out of path of saw blade.
•DO-Shut off power, disconnect cord from power source and wait for saw blade to stop before servicing or adjusting tool.
•DO-Support long work with an outboard tool rest.
•DO-Use only 10 inch diameter blades.
•DON’T-Attempt to operate on anything but designated voltage.
•DON’T-Operate unless all clamp handles are tight.
•DON’T-Use blades larger or smaller than those which are recommended.
•DON’T-Wedge anything against fan to hold motor shaft.
•DON’T-Force cutting action. (Stalling or partial stalling of motor can cause major damage. Allow motor to reach full speed before cutting.)
•DON’T-Cut ferrous metals (Those with any iron or steel content) or any masonry.
•DON’T-Use abrasive wheels. The excessive heat and abrasive particles generated by them will damage saw.
•DON’T-Allow anyone to stand behind saw.
•DON’T-Apply lubricants to the blade when it’s running.
•DON’T-Place either hand in the blade area when the saw is connected to the power source.
•DON’T-Use blades rated less than 5500 R.P.M.
•DON’T-Attempt to cut small pieces (hand within 6" of blade) without clamping.
•DON’T-Operate saw without guards in place.
If you have any questions, call 1-800-54-HOW-TO
•DON’T-Perform any operation freehand.
•DON’T-Reach around or behind saw blade.
•DON’T-Place hands closer than 6 inches from the saw blade.
•DON’T-Reach underneath the saw unless it is turned off and unplugged. The saw blade is exposed on the underside of the saw.
•DON’T-Move either hand from saw or workpiece or raise arm until blade has stopped.
•DON’T-Use without Kerf Plate or when kerf slot is wider than 3/8"
•DON’T- Carry saw by work extension or other accessory.
CAUTION: Some wood contains preservatives such as copper chromium arsenate (CCA) which can be toxic. When cutting these materials extra care should be taken to avoid inhalation and minimize skin contact.
CAUTION: Use of this tool can generate dust containing chemicals known to cause cancer, birth defects or other reproductive harm. Use appropriate respiratory protection.
CAUTION: Do not connect unit to electrical power source until complete instructions are read and understood.
For your convenience and safety, the following warning labels are on your miter saw.
ON MOTOR HOUSING:
WARNING: FOR YOUR OWN SAFETY, READ INSTRUCTION MANUAL BEFORE OPERATING SAW. WHEN SERVICING, USE ONLY IDENTICAL REPLACEMENT PARTS. ALWAYS WEAR EYE PROTECTION.
8
