![](/images/new-backgrounds/1113293/11329315x1.webp)
CLEARING JAMS AND TANGLED LINES | |
From time to time, especially when cutting thick or stalky weeds, | |
the line feeding hub may become clogged with sap or other | |
material and the line will become jammed as a result. To clear | |
the jam, follow the steps listed below. | |
1. Press the release tabs on the line | 9 |
hub cap, as shown in Figure 9 |
|
and remove the cap by pulling it |
|
straight off. |
|
2. Lift the spool of nylon line out of |
|
the hub and clear any broken line |
|
or cutting debris from the spool |
|
area. (If you plan to replace the |
|
spool or rewind it, this is the place |
|
to do so, otherwise, move on.) |
|
3. Unwrap about one foot (30 cm) of |
|
line to ensure that itʼs undamaged. | 10 |
If it is OK rewind it and insert the |
|
line end through the eyelet in the |
|
spool hub as shown in Figure 10. |
|
Pull 4 in. (10 cm) of the line |
| 11 |
through the hole and maintain |
| |
tension while placing the spool |
| |
down into the hub with the arrow |
| |
up, as shown in Figure 11. |
|
|
4. Press the spool down GENTLY |
| |
and rotate it until you feel it drop |
| |
into place. (When in place, the |
| |
spool will turn a few degrees left |
| |
and right freely). Takecare to |
| |
keep the line from becoming |
|
|
trapped under the spool. |
|
|
5. Snap the hub cap back on, and |
| |
power the tool on. In a few seconds or less youʼll hear the nylon | ||
line being cut automatically to the proper length. | ||
• For trouble free feeding and best results, only use | ||
Black & Decker replacement spools with single 0.065 inch line. | ||
Black & Decker replacement spool model number | ||
SPOOL OR LINE REPLACEMENT (Use .065 in. (1.65mm) | ||
diameter ROUND line only) |
|
|
1. Perform step 1 above to remove cap. | ||
2. Remove the spool from the tool and remove and discard all line | ||
on the spool. | OPTION 2 below for spool or line | |
3. Choose either OPTION 1 or | ||
replacement. Perform steps listed under Option 1 or Option 2, | ||
then continue with steps 4 through 6 below. |
4. Insert the line end through the eyelet in the spool hub, as shown in Figure 10. Pull the line through the hole to maintain tension while placing the spool down into the hub, as shown in
Figure 11.
5. Press the spool down GENTLY and rotate it until you feel it drop into place. (When in place, the spool will turn a few degrees left
| and right freely). Takecare to keep the line from becoming trapped |
8 | under the spool. |
|