Black & Decker DCM1400B Care and Cleaning, Sneak-A-Cup Interrupt Feature, Caring For Your Carafe

Models: DCM1400 DCM1400B

1 13
Download 13 pages 9.06 Kb
Page 4
Image 4
SNEAK-A-CUP® INTERRUPT FEATURE

DCM1400Pub178998RV1 8/9/05 12:40 PM Page 6

1.Turn unit off.

2.Wait 10 minutes to prevent hot water in tubes from splashing out.

3.Follow instructions in "BREWING COFFEE".

SNEAK-A-CUP® INTERRUPT FEATURE

You can pour a cup of coffee while coffee is brewing without leaking from the brew basket.

When finished pouring coffee, place the carafe under brew basket (C). The brewing Programming the Coffeemaker for Auto Brew (D) process continues.

 

Important: To avoid possible overflow after removing the carafe,

 

be sure to replace the carafe under the brew basket within one

 

minute or less.

 

Programming the Coffeemaker for Auto Brew (D)

 

Be sure clock is set for the current time of day see "SETTING

C

THE CLOCK."

1. To preset the coffeemaker to begin brewing at a certain time

 

 

first follow steps (1-9) in "BREWING COFFEE."

2. To program the coffeemaker for Auto Brew:

 

To clean inside of reservoir cover, open the one piece cover

 

 

allowing it to rest in the open position. Pull water spreader out

 

 

from under the guide, wipe surfaces with a damp cloth, then

 

 

place water spreader under guide and close the cover (E).

 

5.

Insert filter holder into place.

 

CARING FOR YOUR CARAFE

E

A damaged carafe may result in possible burns from a hot liquid.

To avoid breaking:

Do not allow all liquid to evaporate from the carafe while on the "Keep Hot" plate or heat the carafe when empty.

Discard the carafe if damaged in any manner. A chip or crack could result in breakage.

Never use abrasive scouring pads or cleansers, they will scratch and weaken the glass.

Do not place the carafe on or near a hot gas or electric burner, in a heated oven, or in a microwave oven.

Avoid rough handling and sharp blows.

MINERAL DEPOSITS AND CLOGGING

Mineral deposits left by hard water can clog your coffeemaker. Excessive steaming or a

D

a.Press and continue to hold down the PROG button with one finger while you press the HOUR, then MIN buttons

until desired brew time is reached. Be sure to watch for the P.M. indicator in the digital display.

b. When you let go of the PROG button, the auto time is

prolonged brewing cycle are signs that a cleaning is needed. Cleaning is recommended every 3 months.

1.

Pour white vinegar into the water reservoir up to the 4-cup level on the water window.

 

Add fresh water up to the 6-cup line, and close the reservoir lid.

2.

Press brew basket release button to expose brew basket.

set.

3.Press the AUTO button. The auto light illuminates, indicating the timer is activated.

4.To check your preset auto brewing time, press PROG and view display. When you release the PROG button, the clock displays the current time of day.

5.To automatically repeat brewing at the same preset auto-on time, prepare your coffeemaker for brewing again and press the AUTO button. The AUTO light illuminates.

Note: The auto-brew function can be cancelled at any time by pressing the OFF button. The AUTO light goes out.

Care and Cleaning

CLEANING YOUR COFFEEMAKER

This product contains no user serviceable parts. Refer service to qualified service personnel.

Caution: The control panel is not waterproof. Do not overexpose the control panel to water. Water may cause permanent damage and make the coffeemaker inoperable.

CLEANING

1.Be sure the unit is unplugged and cooled.

2.Remove the filter holder by lifting the basket straight up.

3.Discard the paper filter with the grounds.

4.Clean parts as follows:

Filter holder, carafe and lid are all top rack dishwasher safe; or they may be hand washed in warm, sudsy water.

Wipe the exterior and the "Keep Hot" plate with a soft damp cloth. Do not use abrasive cleansers or scouring pads. Never immerse the coffeemaker in water.

3.

Put a new paper filter in the brew basket, swing the basket closed and be sure it latches.

 

Set the empty carafe on the "Keep Hot" plate.

4.

Turn the coffeemaker on and let half the cleaning solution brew into the carafe. Turn

 

the coffeemaker off and let it soak for at least 15 minutes to soften the deposits.

5.

Turn the coffeemaker on and brew the remaining cleaning solution into the carafe.

6.

When the cleaning solution has finished brewing, discard the paper filter empty the

 

carafe and rinse with clean water.

7.

Refill the reservoir with cold water to the 10-cup line, replace the empty carafe, put a

 

paper filter in the brew basket, then turn on the coffeemaker and run another brew

 

cycle to flush out the remaining cleaning solution.

8.

Wash the brew basket and carafe and carafe lid as instructed in "Care and Cleaning."

5

6

Page 4
Image 4
Black & Decker DCM1400B Care and Cleaning, Sneak-A-Cup Interrupt Feature, Programming the Coffeemaker for Auto Brew D