Keyless single sleeve chuck (DR340) |
|
| |
| This tool is equipped with a feature that automatically locks the spindle when the tool is | ||
| not running. This feature is a normal condition which allows for tightening or loosening of | ||
• | the chuck with one hand while holding the drill with the other. |
| |
To change accessories, loosen the chuck by rotating the sleeve counterclockwise as | |||
• | viewed from the chuck end. |
|
|
Insert the accessory shaft into the chuck to about 3/4in. (19 mm) depth, centered in the | |||
• | jaws. |
|
|
Tighten securely by rotating the sleeve in the clockwise direction as viewed from the | |||
| chuck end. |
|
|
Chuck and key (DR560) (fig. D) | D | 4 | |
• | Open the chuck (4) by turning the collar |
| |
| counterclockwise (when viewed from the |
|
|
• | chuck end). |
|
|
Insert the accessory shaft into the chuck to |
|
| |
| about 3/4 in. (19 mm) depth, centered in the | 7 |
|
• | jaws. |
| |
Tighten chuck collar by hand. Place chuck |
|
| |
| key (7) into each of the three holes and |
|
|
| securely tighten in a clockwise direction. |
|
|
| NOTE: Tighten chuck with all three holes to |
|
|
| prevent slippage. |
|
|
Removing and attaching the chuck (fig. E) |
| ||
Keyless chuck (DR260, DR340) |
|
| |
• | Open the chuck (4) as far as possible. | E |
|
• | Remove the chuck retaining screw (11), |
| 13 |
| located in the chuck, by turning it clockwise |
| |
• | using a screwdriver (lefthand thread). |
|
|
Tighten an allen key (12) of 1/4in. (6mm) or |
|
| |
| greater size (not supplied) into the chuck |
|
|
| and strike it with a soft hammer (13) in a |
|
|
| clockwise direction as shown. |
|
|
• Remove the allen key. |
| 11 | |
• | Remove the chuck by turning it | 12 | |
• | counterclockwise. | 4 | |
To attach the chuck, screw it onto the spindle |
|
| |
| and secure it with the chuck retaining screw. |
|
|
Keyed chuck (DR560) (fig. F) |
|
| |
• | Place chuck key (7) in any one of the three holes in the chuck (4). |
| |
• | Using a soft hammer (13), strike the key in | F |
|
| a clockwise direction. This will loosen the |
| |
| screw (11) inside the chuck. |
|
|
• Open chuck jaws fully and remove the |
|
| |
| chuck retaining screw, located in the chuck, |
| 13 |
| by turning it clockwise using a screwdriver |
| |
| (lefthand thread). |
|
|
• Place key in chuck. Using a soft hammer |
| 4 | |
| (13), strike key sharply in a counterclockwise | 7 | |
• | direction. |
| |
Remove the chuck by turning it |
|
| |
• | counterclockwise. |
|
|
To attach the chuck, screw it onto the spindle |
|
| |
| and secure it with the chuck retaining screw. |
| 11 |
|
|
| |
7
