6
6C
6B
6A
6D
6 WATER SUPPLY CONNECTIONSThread the ½” NPSM Adapter (6A) into the ⅝” Nut (6B). Tighten using wrenches on both the Adapter and the Nut. Make connection to the Faucet Inlet (6C). Repeat for the other tube. Connect water Supply Lines (6D) to Faucet Inlets (6C). (Supply lines and fittings are not included).
ENGLISH 8 | 8D |
| 8B |
| 8A |
8D
8C
8C
8 SOAP DISPENSER HEAD INSTALLATIONPour liquid soap (not included) into the Shank Opening (8A). Install Dispenser Mechanism (8B) into Dispenser Head(8D). Insert Dispenser Head (8D) and Dispenser Mechanism (8B) into Soap Dispenser Body (8C).
9
9A
9B
7
7A
7B
7C
7D
7 SOAP DISPENSER INSTALLATIONInsert threaded Shank (7A) of soap dispenser body through Rubber Gasket (7B) and sink hole. Tighten Nut (7C) and thread on Bottle (7D) to Shank (7A).
3
Insert Lift Rod (9A) into hole at the back of Spout Hub (9B). Gently, slide Lift Rod (9A) down the hole in Spout Hub (9B).
POP-UP DRAIN BODY INSTALLATION STEPS
10
10A10B10E | 10D |
|
Apply a small bead of plumber’s putty underneath the Flange (10A) and place a ring of putty around Drain Opening (10B) of sink. Use PTFE plumber’s tape on all threaded fittings according to manufacturer’s instructions. Insert Flange (10A) into Drain Opening (10B). From underneath, thread Drain Body (10C) to bottom of Flange (10A). Thread Locknut (10D) until Rubber Washer (10E) seats securely inside Drain Opening (10B). Hand tighten and adjust the Drain Body so that the Ball Rod Opening (10F) faces the rear. Wipe excess putty.