Labels on tools
Warning! To reduce the risk of injury, the user must read the instruction manual.
Additional safety instructions for batteries and chargers
Batteries
Never attempt to open for any reason. Do not expose the battery to water. Do not expose the battery to heat.
Do not store in locations where the temperature may exceed 40 °C.
Charge only at ambient temperatures between 10 °C and 40 °C.
Charge only using the charger provided with the tool. When disposing of batteries, follow the instructions given in the section "Protecting the environment".
Chargers
Use your Black & Decker charger only to charge the battery with which it was supplied. Other batteries could burst, causing personal injury and damage.
Never attempt to charge
Do not expose the charger to water. Do not open the charger.
Do not probe the charger.
Features
1.Quick release collar
2.Speed selector switch
3.Torque adjust collar
4.Pivot lock release button
5.Battery release buttons (on battery)
6.Battery
7.On/off trigger switch
8.Forward/reverse and
Assembly
Fitting and removing the battery (fig. A)
Warning! Make sure that the
To fit the battery (6), line it up with the receptacle on the tool. Slide the battery (6) into the receptacle and push until the battery (6) snaps into place.
To remove the battery (6), push the two release buttons
(5)simultaneously while at the same time pulling the battery (6) out of the receptacle.
Charging the battery (fig. C)
This battery is shipped in a partially charged state. Charge the battery before first use using the mains charger (9) for nine hours.
The battery (6) needs to be charged whenever it fails to produce sufficient power on jobs that were easily done before. When charging the battery (6) for the first time, or
+40ºC
+10ºC
The charger is intended for indoor use only.
Read the instruction manual before use.
Charge only at ambient temperatures between 10 °C and 40 °C.
after prolonged storage, it will only accept an 80% charge.
After several charge and discharge cycles, the battery (6) will attain full capacity. The battery (6) may become warm while charging; this is normal and does not indicate a problem.
After normal usage the battery (6) will be fully charged in approximately three to six hours.
Electrical safety
Your charger is double insulated; therefore no earth wire is required. Always check that the power
supply corresponds to the voltage on the rating plate.
Warning! Never attempt to replace the charger unit with a regular mains plug.
If the supply cord is damaged, it must be replaced by the manufacturer or an authorised Black & Decker Service Centre in order to avoid a hazard.
To prolong battery life, do not leave the battery on charge for extended periods of time (over 30 days without use). This can significantly reduce battery life.
Fitting the battery cap (fig. D)
Warning! Fit the cap (10) to the battery (6) for transportation and storage.
Use
Pivoting the tool head (fig. B)
The tool can be pivoted to three different positions (fig. B). To avoid being pinched at the points indicated by the arrows, hold the screwdriver at both ends and use your
6 |
