90503227 ISD600 Impact Driver 6/15/06 12:52 PM Page 7

adjustment (other than those listed in this manual) should be performed by authorized service centers or other qualified service personnel, always using identical replacement parts.

TROUBLESHOOTING

Problem

Possible Cause

Possible Solution

• Unit will not start.

• Battery not charged.

• Check battery charging

 

 

requirements.

• Battery will not charge.

• Charger not plugged in.

• Plug charger into a

 

 

working outlet. Refer to

 

 

“Important Charging

 

 

Notes” for more details.

 

 

• Check current at

 

 

receptacle by plugging in

 

 

a lamp or other appliance.

 

 

• Check to see if

 

 

receptacle is connected to

 

 

a light switch which turns

 

 

power off when you turn

 

 

out the lights.

 

• Surrounding air temperature

• Move charger and tool

 

too hot or too cold.

to a surrounding air

 

 

temperature of above 40

 

 

degrees F (4,5°C) or

 

 

below 105 degrees F

 

 

(+40,5°C).

For assistance with your product, visit our website www.blackanddecker.com for the location of the service center nearest you or call the BLACK & DECKER help line at

1-800-544-6986.

Accessories

Recommended accessories for use with your tool are available from your local dealer or authorized service center. If you need assistance regarding accessories, please call:

1-800-544-6986.

WARNING: The use of any accessory not recommended for use with this tool could be hazardous.

Battery Removal

Before attempting to disassemble this tool, turn it on and run it in either direction until it stops to ensure a complete discharge of the batteries. Using a phillips screwdriver, remove the screws in the product housing and lift the housing half from the tool. Disconnect the terminal clips from the batteries and lift the batteries out. See “Service Information” for battery replacement.

The RBRC™ Seal The RBRC™ (Rechargeable Battery Recycling Corporation) Seal on the nickel- metal hydride battery (or battery pack) indicates that the costs to recycle the battery (or battery pack) at the end of its useful life have already been paid by Black & Decker. In some areas, it is illegal to place spent nickel-metal hydride batteries in the trash or municipal solid waste stream and the RBRC program provides an environmentally conscious alternative.

RBRC in cooperation with Black & Decker and other battery users, has established programs in the United States and Canada to facilitate the collection of spent nickel-metal hydride batteries. Help protect our environment and conserve natural resources by returning the spent nickel-metal hydride battery to an authorized Black & Decker service center or to your local retailer for recycling. You may also contact your local recycling center for information on where to drop off the spent battery, or call 1-800-8-BATTERY.

7

Page 7
Image 7
Black & Decker 90503227, ISD600 instruction manual Problem Possible Cause Possible Solution, Accessories, Battery Removal