Warning ! Allow moving parts to come to a stop before approaching.
Assembling the juicer
•Wash all detachable parts (see chapter ‘Maintenance and cleaning’).
•Place the juice collector (G) on to the motor base (H).
•Put the rotary sieve (F) in the juice collector
•Make sure the rotary sieve (F) is fitted securely onto the driving shaft (‘click’).
•Always check the rotary sieve (F) before use. If you detect any cracks or damage, do not use the appliance and contact the nearest service centre or take the appliance to your dealer.
•Place the juicer lid (E) onto the juice collector
•Lock the clamp (J) onto the juicer lid (E) to lock it into place (‘click’) and slide the pusher
(D)into the feeding tube by aligning the groove in the pusher with the small protrusion on the inside of the feeding tube. Never insert your fingers or an object into the feeding tube.
•Place the pulp collector (K) in to position at the side of the juicer.
•Place a jug under the spout.
Assembling the Blender
•Wash all detachable parts (see chapter ‘Maintenance and cleaning’).
•Fit the blender jug (C), to the motor base (H) and secure by turning it
Note: Ensure that the blender is switched off before removing it from the stand.
Assembling the grinder
•Wash all detachable parts (see chapter ‘Maintenance and cleaning’).
ENGLISH
•Fit the grinder seal (P) into the groove around the edge of the grinder blade (Q).
•Secure the blade (Q) into the grinder jug (O) by pushing it into the jug and turning it clockwise.
•Fit the grinder jug (O) to the motor base (H) and secure it by turning it
Assembling the mincer
•Wash all detachable parts (see chapter ‘Maintenance and cleaning’).
•Fit the mincer seal (M) into the groove around the edge of the mincer blade (N).
•Secure the blade (N) into the mincer jug (L) by pushing it into the jug and turning it clockwise.
•Fit the mincer jug (L) to the motor base (H) and secure it by turning it
Use
The following settings are available:-
P = Pulse Operation
O = Power Off
1 = Low Speed
2 = High Speed
The appliance should be disconnected from the mains supply before removing the jug.
Using the juicer
•Place the appliance on a flat, stable surface and connect it to the electrical supply.
•Select the required speed (P, 1 or 2) using the CONTROL KNOB (I).
•Remove the pusher & add the ingredients, using the pusher to guide the ingredients onto the blades.
While you are preparing juice, you can empty the pulp container by switching the appliance off and carefully removing the pulp container.
5
