Black & Decker LCS120 Care and Maintenance, Oil Level, Chain and Bar, Saw Chain Sharpening

• (Figure U) When supported at both ends
First, cut 1/3 down from the top overbuck. Then make the finished
cut by underbucking the lower 2/3 to meet the first cut.
U		1st CUT OVERBUCK (1/3
	1	DIAMETER) TO AVOID
		SPLINTERING
	2	2nd CUT UNDERBUCK (2/3
		DIAMETER) TO MEET 1st CUT
		(TO AVOID PINCHING)

•	(Figure V) When on a slope
	Always stand on the uphill side of	V	STAND ON
	the log. When "cutting through", to
	maintain complete control release		UPHILL
	the cutting pressure near the end		SIDE
	of the cut without relaxing your		WHEN
	grip on the chain saw handles.		CUTTING
	Don't let the chain contact the		BECAUSE
	ground. After completing the cut,		LOG MAY
	wait for the saw chain to stop		ROLL
	before you move the chain saw.
•	Always stop the motor before moving from tree to tree.
	(Figure W) When using a saw	W
	horse
	This is strongly recommended
	whenever possible. Position the
	log in a stable position. Always cut
	on the outside of the saw horse
	arms.

15

CARE AND MAINTENANCE

Use only mild soap and damp cloth to clean the tool. Do not use solvents to clean the plastic housing of the saw. Never let any liquid get inside the tool; never immerse any part of the tool into a liquid. IMPORTANT: To assure product SAFETY and RELIABILITY, repairs, maintenance and adjustment should be performed by authorized service centers or other qualified service organizations, always using identical replacement parts.

Regular maintenance ensures a long effective life for your chain saw. We recommend you make the following checks on a regular basis:

Oil Level

The level in the reservoir should not be allowed to fall below a quarter full.

Chain and Bar

After every few hours of use, remove the guide bar and chain and clean thoroughly.

Saw Chain Sharpening

CAUTION: Sharp chain. Always wear protective gloves when handling the chain. The chain is sharp and can cut you when it is not running.

WARNING: Sharp moving chain. To prevent accidental operation, insure that battery is disconnected from the tool before performing the following operations. Failure to do this could result in serious personal injury.

To get the best possible performance from your chain saw it is important to keep the teeth of the chain sharp. Follow these helpful tips for proper saw chain sharpening:

1. For best results use a 4.5mm file and a file holder or filing guide to sharpen your chain. This will ensure you always get the correct sharpening angles.

2. Place the file holder flat on the top plate and depth gauge of the cutter.