Black & Decker LCS120 instruction manual Important Safety Instructions

upper portion of the tip of the guide bar contacts an object, such	SAFETY INSTRUCTIONS AND
as a log or branch.
• Limbing - Removing the branches from a fallen tree	WARNINGS FOR CHAIN SAWS
• Low-Kickback Chain - A chain that complies with the kickback	• Keep Work Area Clean -Cluttered areas invite injuries. Do not
performance requirements of ANSI B175.1-1991 (when tested on	start cutting until you have a clear work area, secure footing, and a
a representative sample of chain saws.)	planned retreat path from the falling tree.
• Normal Cutting Position - Those positions assumed in	• Consider Work Area Environment - Use extreme caution when
performing the bucking and felling cuts.	cutting small size brush and saplings because the slender material
• Notching Undercut - A notch cut in a tree that directs the treeʼs fall.	may catch the saw chain and be whipped toward you or pull you off
• Oiler Control - A system for oiling the guide bar and saw chain.	balance. When cutting a limb that is under tension be alert for spring
• Rear Handle - The support handle located at or toward the rear	back so that you will not be struck when the tension in the wood
of the saw.	fibers is released. Do not expose chain saw to rain or snow. Do not
• Reduced Kickback Guide Bar - A guide bar which has been	use chain saw in damp or wet locations or while it is raining or
demonstrated to reduce kickback significantly.	snowing. Do not use chain saw in the presence of flammable liquids
• Replacement Saw Chain - A chain that complies with kickback	or gases or enclosed concentrations of dust. Cut only when visibility
performance requirements of ANSI B175.1-2000 when tested	and light are sufficient to see clearly
with specific chain saws. It may not meet the ANSI performance	• Keep Children, Bystanders, Visitors and Animals Away - Do
requirements when used with other saws.	not let visitors contact chain saw. All visitors should be kept away
	from work area.
• Saw Chain - A loop of chain having cutting teeth, that cut the	• Store Idle Chain Saw - When not in use, chain saws should be
wood,and that is driven by the motor and is supported by the	stored in a dry, and high or locked-up place - out of the reach of
guide bar.	children. When storing saw, always remove battery and use a
• Ribbed Bumper - The ribs used when felling or bucking to pivot	scabbard or carrying case.
the saw and maintain position while sawing.	• Don't Force Chain Saw - It will do the job better and safer at the
• Switch - A device that when operated will complete or interrupt	rate for which it was intended.
an electrical power circuit to the motor of the chain saw.	• Use Right Tool - Cut wood only. Don't use chain saw for purpose
• Switch Linkage - The mechanism that transmits motion from a	not intended - for example - Don't use chain saw for cutting plastic,
trigger to the switch.	metal, masonry, non-wood building materials.
• Switch Lockout - A movable stop that prevents the unintentional	• Dress Properly - Do not wear loose clothing or jewelry. Keep your
operation of the switch until manually actuated.	hair, clothing, and gloves away from moving parts. Loose clothing,
IMPORTANT SAFETY INSTRUCTIONS	jewelry, or long hair can be caught in moving parts. Wear protective
	should be avoided. Protective non-slip gloves and non-skid footwear
WARNING: When using a battery operated chain saw, basic	hair covering to contain long hair. Air vents cover moving parts and
	are recommended when working outdoors. Always wear heavy,
safety precautions should always be followed to reduce risk of fire,	long pants or other protection for your legs.
electric shock, and personal injury, including the following:	• Use Safety Glasses - Also use safety footwear; snug fitting
READ ALL INSTRUCTIONS	clothing; protective gloves; proper hearing, respiratory, and head
	protection.
3	• Carrying Saw - Carry the chain saw by the front handle with the