IMPORTANT SAFETY INSTRUCTIONS
FOR BATTERY CHARGERS
SAVE THESE INSTRUCTIONS: This manual contains important safety instructions for battery chargers.
• BeforeWARNING:using charger,read all instructionsand cautionary markings on charger,battery pack, and product using battery pack.
to getCAUTION:inside charger. Shock hazard. Do not allow any liquid Burn hazard. To reduce the risk of injury,
chargeCAUTION:only designated Black & Decker batteries. Other types of batteries may burst causing personal injury and damage.
Under certain conditions, with the
charger plugged in to the power supply, the charger can be shorted by foreign material. Foreign materials of a conductive nature such as, but not limited to, steel wool, aluminum foil, or any buildup of metallic particles should be kept away from charger cavities. Always unplug the charger from the power supply when there is no battery pack in the cavity. Unplug charger before attempting to clean.
• The charger supplied with this product is intended to be plugged in such that it is correctly orientated in a vertical or floor mount position.
• DO NOT attempt to charge the battery pack with any chargers other than the ones in this manual. The charger and battery pack are specifically designed to work together.
• These chargers are not intended for any uses other than charging designated Black & Decker rechargeable batteries. Any other uses may result in risk of fire, electric shock or electrocution.
• Do not expose charger to rain or snow.
• Pull by plug rather than cord when disconnecting charger. This will reduce risk of damage to electric plug and cord.
• Make sure that cord is located so that it will not be stepped on, tripped over, or otherwise subjected to damage or stress.
• | Do not use an extension cord unless it is absolutely necessary. | |||||||||
| Use of improper extension cord could result in risk of fire, electric | |||||||||
• | shock, or electrocution. |
|
|
|
| |||||
An extension cord must have adequate wire size (AWG or | ||||||||||
| American Wire Gauge) for safety. The smaller the gauge number | |||||||||
| of the wire, the greater the capacity of the cable, that is 16 gauge | |||||||||
| has more capacity than 18 gauge. When using more than one | |||||||||
| extension to make up the total length, be sure each individual | |||||||||
| extension contains at least the minimum wire size. | |||||||||
| Recommended Minimum Wire Size for Extension Cords | |||||||||
|
|
| Volts | Minimum Gauge for Cord Sets |
| |||||
|
|
|
| |||||||
|
|
| Total Length of Cord in Feet |
| ||||||
|
|
| 120V |
|
| |||||
|
|
| 240V |
|
| |||||
|
|
| Ampere Rating | American Wire Gauge |
| |||||
|
|
| More Not more |
| ||||||
|
|
| Than Than |
|
|
|
|
| ||
|
|
| 0 | - | 6 | 18 | 16 | 16 | 14 |
|
|
|
| 6 | - | 10 | 18 | 16 | 14 | 12 |
|
|
|
| 10 | - | 12 | 16 | 16 | 14 | 12 |
|
• | Do not |
| 12 | - | 16 | 14 | 12 | Not Recommended |
| |
| place any object on top of charger or place the charger | |||||||||
| ||||||||||
| on a soft surface that might block the ventilation slots and | |||||||||
| result in excessive internal heat. Place the charger in a position | |||||||||
| away from any heat source. The charger is ventilated through | |||||||||
• | slots in the top and the bottom of the housing. | |||||||||
Do not mount charger on wall or permanently affix charger to | ||||||||||
| any surface. The charger is intended to use on a flat, stable surface | |||||||||
• | (i.e., table top, bench top). |
|
|
| ||||||
Do not operate charger with damaged cord or plug — have | ||||||||||
• | them replaced immediately. |
|
|
| ||||||
Do not operate charger if it has received a sharp blow, been | ||||||||||
| dropped, or otherwise damaged in any way. Take it to an | |||||||||
• | authorized service center. |
|
|
|
| |||||
Do not disassemble charger; take it to an authorized service | ||||||||||
5 | center when service or repair is required. Incorrect reassembly may | |||||||||
result in a risk of electric shock, electrocution or fire. | ||||||||||
