Snapper dimensions INSTRUCTION #2-9693I.R. 8/94

STEP 5: Secure bracket and ground wire to auger housing with nuts; washers and bolts supplied with kit. See Figure 5.

STEP 6: Follow steps as described in #6-0770 Battery Kit to activate battery for mounting and usage.

STEP 7: Install battery and connect ground wire (black ground wire found in kit #6-0651) to negative terminal side of battery with nut and bolt as shown. Tighten nut and bolt securely; do not over tighten. See Figure 5 & 7.

STEP 8: Before mounting jump start switch connect positive red wire (longer red wire that mounts to battery) to switch button as shown. See Figure 6. Mount jump start switch onto control panel using nuts and bolts found in kit #6-0646 Jump Start Kit. See Figure 5.

STEP 9: Loosen nut that secures cable guide to engine base. Install black wire from jump start switch to stud and reinstall nut and tighten securely. See Figure 5.

STEP 10: Remove nut from starter motor and mount shorter red wire from jump start switch and reinstall nut and tighten securely. See Figure 5.

STEP 11: Before mounting positive red wire drill the end that mounts to battery terminal to 1/4” diameter. Mount positive wire (red) and charging wire to positive terminal side of battery with nut and bolt as shown. See Figure 5. NOTE: There are two different charging wires found in #6-0651 Battery Mounting Kit. Visually check charging wire and use the wire that corresponds with correct male and female connectors found on engine. Connect charging wire (male connector) into engine wire (female connector). Connect light wire harness (male connector) into charging wire (female connector).

STEP 12: Mount battery cover and secure with washers and wing nuts as shown. See Figure 7. Make sure all nuts and bolts are tight. All wire connections should be securely connected.

		BATTERY
		COVER
JUMP START
SWITCH
BLACK	ENGINE WIRE
WIRE		GROUND
	POSITIVE RED	WIRE
SHORTER RED		GROUND
	WIRE (TO
WIRE (TO	BATTERY)	WIRE

STARTER)	POSITIVE
	TERMINAL
	NEGATIVE
	TERMINAL

STARTER

MOTOR

BATTERY

CABLE

STUD GUIDE CHARGING BATTERY

WIREMOUNTING

BRACKET

BATTERY

CLAMP

FIGURE 5

BLACK	FIGURE 7
WIRE
	SHORTER
	RED WIRE
	(TO STARTER)

JUMP START	DRILL 1/4”
SWITCH
ASSEMBLY	RED WIRE
	POSITIVE
	RED WIRE
	(TO BATTERY)
	FIGURE 6
INSTRUCTION #2-9693 (I.R. 8/94)	PRINTED IN U.S.A.