ELECTRIC START SYSTEM DEALER
SNAPPER LARGE FRAME SNOW THROWERS
INTRODUCTION: It will be necessary to complete Dealer
WARNING: Always disconnect spark plug wire from spark plug before performing maintenance on snow thrower. DO NOT operate snow thrower without guards in place. DO NOT put hands into areas that house rotating parts while machine is in operation!
STEP 1: Drill two 5/16 diameter holes in right side of auger housing using dimensions shown. See Figure 1.
5/16 DIAMETER
HOLES AUGER HOUSING
4”
FIGURE 1
STEP 2: Drill two 5/16 diameter holes in control panel within the 5” by 7” boundary lines shown. Drill holes using dimensions shown. See Figure 2.
BOUNDARY
LINES
CONTROL
PANEL
5”
7”
5/16 DIAMETER HOLES
FIGURE 2
STEP 3: Install light onto control panel with washer and nut and tighten securely. Install light wire harness into end of light wire and route down handle and secure with ties as shown. See Figure 3.
LIGHT
TIE
LIGHT WIRE
HARNESS
TIE
FIGURE 3
STEP 4: Remove battery mounting bracket and battery clamp from
BATTERY CLAMP
BATTERY MOUNTING
BRACKET
BEND TAB OVER
FIGURE 4
INSTRUCTION