Black & Decker LST1018 instruction manual To Attach

•Insert the 3/4 inch (19mm) screw as shown in figure F to complete the guard assembly.

TO ATTACH:

• Place the assembled guard over the spool as shown in figure G and insert the remaining three screws into the guard as. indicated by the arrows

• Once the guard is installed, remove the covering from the line cut-off blade, located on the edge of the second guard section.

PushAuxilIarythe auxillaryhandlehandleattachmonto thentupper H tube. Position the handle so that the groove

in the tube is located in the middle of the handle opening. Insert the handle bolt through the hole in the handle as shown in figure H and I.

I

AUXILIARY HANDLE ADJUSTMENT For maximum comfort and control, adjust the auxiliary handle to suit your height (figure J). Shorter users adjust handle to a lower position (away from you) and taller users, adjust handle to an upper position (towards you). The handle should be adjusted so that your front arm is straight as shown in figure M.

10