CONVERT TO EDGING MODE | 10 |
• To operate as a maintenance edger, turn | |
the collar (i) as shown in part 1 of |
|
figure 10. |
|
• Hold the metal shaft and rotate the lower |
|
housing 180° as shown in part 2. |
|
• Turn the collar (i) until tight. |
|
| i |
• If desired, pull the wire edge guide (j) |
|
out from the motor housing until it clicks |
|
into the locked position as shown in figure |
|
11 and position the trimmer above the |
|
surface as shown in figure | 11 |
11. | |
• Return to the trimming |
|
position by loosening the |
|
collar and rotating the lower |
|
housing back 180°. |
|
• Turn the collar until tight. |
|
When using the tool, retract |
|
the wire edge guide to the |
|
original position, out of the |
|
way. |
|
CAUTION: Wire edge |
|
guide should only be used |
|
when in the edging mode. |
|
Keep wire edge guide in the |
|
retracted position when in | j |
the trimming mode. |
Cutting Line / LINE FEEDING
Your trimmer uses .065 inch (1.65 mm) diameter, ROUND nylon line. During use, the tips of the nylon lines will become frayed and worn and the special self feeding spool will automatically feed and trim a fresh length of line. Do not bump unit on ground in attempt to feed line or for any other purposes. Cutting line will wear faster and require more feeding if the cutting or edging is done along sidewalks or other abrasive surfaces or heavier weeds are being cut.
replacement accessories
CAUTION: Before you begin trimming, only use the appropriate type of cutting line.
Use Black & Decker replacement spool Model No.
• USE ONLY .065 inch (1.65 mm) DIAMETER ROUND NYLON MONOFILAMENT LINE. Do not use serrated or heavier gauge line, as they will overload the motor and cause overheating. This line is available at your local dealer or authorized service center.
• Other replacement parts (guards, spool caps, etc.) are available through Black & Decker service centers. To find your local service location call:
WARNING: The use of any accessory not recommended by Black & Decker for use with this tool could be hazardous.
10