ASSEMBLY & ADJUSTMENT
ASSEMBLY TOOLS REQUIRED (NOT SUPPLIED): - Phillips Screwdriver
installing the guard
WARNING: remove the battery before attempting to attach the guard, edge guide or handle. NEVER OPERATE TOOL WITHOUT GUARD FIRMLY IN PLACE. The guard must always be on the tool to protect the user.
Attaching the Auxiliary Handle | |
• To attach the handle, press | 5 |
in on the buttons (f) on both | |
sides of the upper housing as |
|
shown in figure 5. | f |
| |
•Turn the trimmer upside down so that you are looking down at the spool cap (a).
•Turn the guard (b) upside down and slide it onto the motor housing (c). Make sure the tabs (d) on the guard engage the ribs (e) on the motor housing as shown.
•Continue to slide the guard on until you hear it “snap” into place.
•Using a phillips screw- driver, insert the guard screw as shown in figure 4 to complete the guard assembly.
•Once the guard is installed, remove the covering from the line
3 | b |
d | c |
| |
| e |
| a |
4 |
|
• Position the handle as
shown in figure 6 (with the 6 Black & Decker logo facing upward). Partially push the handle on so that it will hold the buttons in when you release them with your hand.
8
