Locking and unlocking the system
In situations where the computer system (and the LOCAL module) can be locked away, the Wizard extender modules offer a viable security system to deter unauthorised use. Once a password has been set, a simple key sequence allows the system to be quickly and securely detached from its peripherals. Only the correct password will reconnect the remote and local modules.
To lock the system
1First set a password. For further details, please refer to the ‘Password setting’ section in the ‘Special configuration’ chapter.
2Simultaneously press the currently configured hotkeys (by default, 
and 
) along with 
.
The screen will go blank and the three keyboard | Scroll |
| k |
indicators will begin alternately flashing between the | Loc |
s | |
‘Num Lock’ and ‘Scroll Lock’, and ‘Caps Lock’. This | Cap k |
Loc | |
sequence indicates that a password is required. | Num |
Loc | |
| k |
To unlock the system
1 Enter the correct password and press 
.
Note: Passwords are NOT case sensitive.
Note: If an invalid password has been entered and the keyboard indicators are not flashing as described above, press 
to clear the incorrect attempt.
2If the correct password is entered, the screen will be restored and normal operation can continue.
To enable the video
Simultaneously press the currently configured hotkeys (by default, 
and 
)
along with 
. This command will be required to restore the video if 
and 
along with 
is used when no password has been set.
To disable the video
Simultaneously, press the currently configured hotkeys (by default, 
and 
) along with 
.
®
13
