10/100Base-TX Hardened PoL/PoE Ethernet Extender

Installation

This chapter gives step-by-step installation instructions for the Hardened Ethernet Extender.

Selecting a Site for the Equipment

As with any electric device, you should place the equipment where it will not be subjected to extreme temperatures, humidity, or electromagnetic interference. Specifically, the site you select should meet the following requirements:

The Surrounding Air temperature should be between -40 to +167 degrees Fahrenheit (-40 to +75 degrees Celsius).

The relative humidity should be less than 95 percent, non-condensing.

Surrounding electrical devices should not exceed the electromagnetic field (RFC) standards.

Make sure that the equipment receives adequate ventilation. Do not block the ventilation holes of the equipment.

The power outlet should be within 6 feet (1.8 meters) of the product.

DIN Rail Mounting

Fix the DIN rail attachment plate to the back panel of the Hardened Ethernet Extender.

Installation: Place the Hardened Ethernet Extender on the DIN rail from above using the slot. Push the front of the Hardened Ethernet Extender toward the mounting surface until it audibly snaps into place.

Removal: Pull out the lower edge and then remove the Hardened Ethernet Extender from the DIN rail.

User’s Manual

13

Page 14
Image 14
Black Box LBPS311A, LBPS310A-KIT, LBPS312A manual Installation, Selecting a Site for the Equipment, DIN Rail Mounting