16
USB DIRECTOR/4-PORT HUB
cable into the Hub’s power connector. The hub will go
through a reset and operate in the bus-powered mode;
however, the bus-powered LED will be off. When the
optional power adapter is connected, USB high-power
devices can be attached to the Hub. Refer to the
instructions supplied with each USB device for
their individual operation.
3.2 Hub Mounting
To stand the hub upright on a desk or shelf, slide the
stand onto the base of the hub. To lay the hub flat, slide
the stand onto the back of the hub. To mount the hub
directly onto a wall, the side of or under a desk (any
vertical or horizontal surface), first secure the stand to
the desired location with two small screws (or any other
technique such as Velcro®strips) and slide the hub on
to the bracket.
3.3 Cable Connections
The standard USB cables are designed to ensure that
they plug into the correct receptacle. Each cable has
a connector that goes upstream toward the host end
(Type A) and a connector that goes toward the down-
stream device end (Type B). The maximum length of