Black Box manual Expansion Module for ServSwitch Affinity, May KV1308C

Expansion Module for ServSwitch™ Affinity

May 2004

KV1308C

Install an Expansion module for the ServSwitch™ Affinity (Product code KV13XA) in your switch unit to prepare that Switch to be interconnected (daisychained) with other ServSwitch™ Affinity units in your system. The RJ45 expansion module can also be used to replace existing HD15 expansion cards. Each Module has a DATA IN and DATA OUT connector, eight BUS IN connectors, and eight BUS OUT connectors as shown in the illustration above. The eight connectors on the right are BUS 1-8 OUT, the center eight connectors are BUS 1-8 IN, and the left two connectors are DATA IN and DATA out. These are used to communicate information between interconnected switches. BUS 1-8 OUT transmit and BUS 1-8 IN receive the video signals to and from other interconnected switches.

Before you install expansion modules in a daisychained ServSwitch Affinity system, you might need to set the SW1 switch, depending on which unit is being set-up. In a “BUS” topology consisting of four ServSwitch Affinity units, set Unit #3, and #2 SW1 switch off. Unit #1 and Unit #4 would have the SW1 switch on.

											SW1
BUS BUS BUS BUS	BUS BUS	BUS BUS	BUS	BUS	BUS	BUS	BUS	BUS	BUS	BUS	DATA DATA
8 OUT 7 OUT 6 OUT 5 OUT	4 OUT 3 OUT	2 OUT 1 OUT	8 IN	7 IN	6 IN	5 IN	4 IN	3 IN	2 IN	1 IN	OUT IN

The 8-Port Expansion Card for the 8-User and 16-User ServSwitch Affinity models have two jumpers labeled JP1 and JP2 that control the numbering of an Affinity chassis’ user ports. If the card is going into an 8-user Affinity chassis, follow the directions printed on the card’s circuit board for the “lower” card, even though there is only one card and its slot is at the top of the chassis:

©Copyright 2004, Black Box Corporation. All rights reserved.

CUSTOMER SUPPORT INFORMATION

Order toll-freein the U.S.; Call 877-877-BBOX(outside U.S. call 724-746-5500)

FREE technical support 24 hours a day, 7 days a week: Call 724-746-5500or fax 724-746-0746

Mailing address: Black Box Corporation, 1000 Park Drive, Lawrence, PA 15055-1018

Web site: www.blackbox.com ∙ E-mail:info@blackbox.com

BLACK BOX and the logo are registered trademarks, and ServSwitch and Affinity ServSwitch are trademarks, of Black Box Corporation