1000 Park Drive • Lawrence, PA
TEL: (724)
©
The information in this document is subject to change without notice. Black Box assumes no responsibility for any errors that may appear in this document. All product names are trademarks of the manufacturer. Specific brands and product names may be trademarks and are the property of their respective companies.
Document Number | January 2005 |
10/100 Autosensing
Media Converter
Installation Guide
10/100 Autosensing Media Converter™ is a
802.3
z
z
z
10/100 Autosensing Media Converter is a 1U high,
Installing 10/100 Autosensing Media Converter
10/100 Autosensing Media Converter comes ready to install. The only adjustments that may need to be made after installation are:
zConfiguring the unit for its mode of operation and other features.
zSetting the twisted pair port for a crossover workstation or pass- through connection.
To install the 10/100 Autosensing Media Converter, first make sure that the unit is placed on a suitable flat surface, leaving some space behind the unit. Attach the cables between the 10/100 Autosensing Media Converter and each device that will be interconnected, then plug the unit into a reliable, filtered power source.
NOTE: All network cables must be connected for link LEDs to glow.
The following diagram shows the faceplate on the 10/100 Autosensing Media Converter. Regardless of the type of fiber connectors, the LEDs operate the same. Refer to page 5 for LED functionality.
Crossover/ Twisted Pair |
| Fiber Optic | SX | ||
LEDs |
|
| |||
switch |
|
|
| port | LEDs |
|
| TX | XMT | RCV |
|
LNK | ACT | 100 |
| SX |
|
X II |
|
|
| 100 |
|
|
|
|
| ACT |
|
|
|
|
| LNK |
|
|
| PWR |
|
|
|
10/100 Mbps |
|
|
|
|
|
|
| 1 |
8 | ||
|
|
|