ACTIVE STAR HUB
3. Active Pair Setup
IMPORTANT!
If you haven’t already done so, please read the safety guidelines listed on page 1.
The factory default active pair setting for the Active Star Hub is pins 4/5. The default and other possible configurations are shown on the identification label located on the rear panel.
MODEL xxxxxx
PINS 4/5 3/6 1/2
S/N xxxxxxxxxx
Figure
You can reconfigure the active pair by following this procedure:
1.Disconnect all power to the unit.
2.Remove the top cover screws located on the rear panel.
3.Gently slide the top cover back one inch.
4.Hold the top cover and tilt it up.
5.Reconfigure the jumpers (located behind the RJ connectors on the circuit board) as required. Settings for polarity and active pair assignment are shown in Figure
10