Black Box SCSI-2 LVD manual Regular NEW Windows NT Installation

ULTRA2 LVD SCSI HOST ADAPTER

5.4.1REGULAR NEW WINDOWS NT INSTALLATION

These instructions will guide you through the installation of the Ultra2 LVD SCSI Host Adapter’s Windows NT driver while installing Windows NT 4.0 itself, either from floppy diskettes or CD-ROM. The Windows NT driver will be found on Driver Disk 1. It is important that the hardware has been installed successfully before proceeding further.

1A. If you are installing Windows NT from floppy diskettes, locate the Windows NT Setup Disk for Floppy Installation. Make a backup copy of this diskette before installation.

1B. If you are installing Windows NT from a CD-ROM drive, locate the Windows NT Setup Disk for CD-ROM Installation. Make a backup copy of this diskette before installation.

2.Insert the backup Windows NT Setup Disk into drive A: and turn on your computer.

3.Follow the instructions on the screen until you come to a window titled “Windows NT Workstation Setup.” Press “ENTER” to continue setting up Windows NT, select “S” to skip mass-storage detection, and select “S” again to configure additional SCSI adapters.

4.When prompted by the Windows NT installation program, scroll down the list and select “Other (Requires Disk Provided by a Hardware Manufacturer)” from the list of “Additional SCSI Adapters.” Following the on-screen instructions, remove the diskette in drive A and set it aside, then insert Driver Disk 1 and press <ENTER>, then select “Initio INI-A100U2W SCSI Host Adapter” and press <ENTER> again.

5.The Adapter’s Windows NT driver is now installed. The on-screen instructions will continue for a complete installation of Windows NT. Refer to your Windows NT user’s manual for the rest of the operating-system installation procedure.

56