Chapter 3: Installation
3.4.1 To enter video compensation mode
1Ensure that the two ServSwitch Wizard
2Arrange your test images on the remote screen. Please refer to the section ‘Test images while compensating’ shown bottom left.
3 On the remote unit, click the miniature switch 1 to its ON position.
2
1
ON
Scrollk
Loc
Capsk
Loc
Numk
Loc
This flash sequence indicates that you are at Standby level
The indicators on the keyboard linked to the remote unit will begin to flash in sequence.
Also, the green indicator adjacent to the CATx link socket will flash.
Note: During video compensation mode, the keyboard and any other connected USB devices will be temporarily isolated from the computer.
You are now at the standby level within video compensation mode.
From standby, you can choose which adjustments to make. Generally you should set the cable type and cable length options first. Then, if necessary, use the video gain and color skew adjustments to fine tune the remote video image.
Please see the next page for details about each adjustment >>>
When your adjustments are complete, return the unit to normal operation as described below:
3.4.2 To exit video compensation mode (return to normal operation)
1Ensure that you are at standby level by exiting from any adjustment options.
2On the remote unit, return the miniature switch 1 to its OFF position.
All USB devices will be reconnected to the computer and normal operation will continue.
Page 25 |