Blaupunkt Car CD Changer operating instructions DSC programming, CDC Name, Speech, Ta Vol

DSC programming

DSC (Direct Software Control) allows you to customise certain programmable, basic settings to suit your personal needs and preferences and then store them.

The basic settings for this audio equipment were made at the factory.

In the following you can find an overview of these settings, so that you can always reset to these if desired.

If you wish to alter any of the programming,

•press DSC.

Use the rocker switch and the button to select and adjust the functions described in the following. The display will show you the adjusted condition.

/ Select function

<<>> Adjust/recall value

CDC NAME	Only available for CD	SPEECH	In future many RDS radio
	changer playback.		stations will differentiate be-
	Use this function to name		tween music and speech
	your CDs. (See “Entering		programmes.
	CD names”).		You can alter the tone for
			speech programmes from
LOUDNESS Loudness - When listening			between “SPEECH 0 ... 4”.
	at a low level, the Loudness		SPEECH 0:
	function creates a more nat-		Music/speech off
	ural sound by boosting the		SPEECH 1:
	low frequency range.
			Linear reproduction (bass,
	LOUD 1 - Low boost
			treble and Loudness set to
	LOUD 6 - Max. boost
			“0”)
TA VOL	To adjust the traffic an-		SPEECH 2-4:
			Different settings for vol-

nouncement and warning	ume, bass and treble with
beep volume from between
	the Loudness being
0 to 63.
	switched off.
The message will then come
	Try out which SPEECH set-
through at this volume, if the
	ting you like most.
standard volume is lower.
Should the standard volume
be higher than the TA VOL
level, then the traffic report
will be played slightly louder
than the standard volume.

50