Blaupunkt CR 24 operating instructions Appendix, Autoreverse function, Technical data, Cassette

Autoreverse function Care of your audio equipment

Appendix

Technical data

(Switching tracks during playback)

•Press FR and FF at the same time.

At the end of the tape, the unit will automati- cally switch to the other track.

Note:

If there is too much tension on the cassette tape during playback, the set may switch to the other track by itself. In this case check the condition of the tape. Sometimes it helps to rewind the cassette tape completely.

We recommend that you use only C60/C90 cassette tapes in your car radio. Protect your cassettes from dirt, dust and temperatures exceeding 50 °C.

During cold weather, allow cold cassettes to warm up somewhat before playing them in order to avoid uneven tape transport. Opera- ting problems and sound distortions may occur after approximately 100 hours of play- ing time and are caused by dust particles which adhere to the rubber roller and the audio head.

Use a cleaner cassette to remove normal dirt build-up. If more dirt than usual has accumu- lated, use a cotton bud dipped in rubbing alcohol to clean these parts. Never use any hard tools.

Amplifier:
Output power:	2 x 10 W RMS power ac-
	cording to DIN 45324/3.1
	into 2 Ω
FM:
Sensitivity:	0.9 ∝V at 26 dB signal-
	to-noise ratio
Frequency
response:	35 - 15 000 Hz (-3 dB)
Cassette:
Frequency
response:	40 - 14 000 Hz (-3 dB)

Subject to modifications!

22