User settings

￿Adjust the desired volume with the rock-

er switch or = (levels 0 to 66).

Notes:

The volume preset by you will not be used,

if the volume currently listened to is lower than the set mute level. In this case, traffic announcements are re- produced with the volume listened to.

if the volume currently listened to is higher than the set TEL volume. In this case, phone calls/navigation an- nouncements are reproduced with the volume listened to.

if the volume currently listened to is higher than the set TA volume. In this case, traffic announcements are re- produced with the volume listened to.

Activating/deactivating the signal tone (BEEP ON/OFF)

You can deactivate the signal tone that sounds as a confirmation in the menus or when storing the stations on the station but- tons.

￿In the Volume menu, press the rock-

er switch or = repeatedly until "BEEP ON/OFF" is displayed.

￿Switch between the settings with the rocker switch or :.

"BEEP OFF" (signal tone off)

"BEEP ON" (signal tone on)

Setting the speed-dependent volume increase (AUTO SOUND)

When you are driving faster, the device can automatically increase the volume to com- pensate for the driving noise. The volume is increased depending upon the speed. In or- der for this to work, the speedometer signal must be connected as described in the in- stallation instructions.

The optimum setting for this volume in- crease depends on how noise levels devel- op in your particular vehicle. Try the setting that is perfect for your vehicle. You can se- lect a value between 0 (no increase) and max. 5.

￿In the Volume menu, press the rock-

er switchor = repeatedly until "AUTO SOUND" is displayed.

￿Press the rocker switch : to display the setting.

￿Set the desired value with the rocker switch or =.

110

Page 49
Image 49
Blaupunkt MP57 Activating/deactivating the signal tone Beep ON/OFF, Setting the speed-dependent volume increase Auto Sound