Blaupunkt PA2100 System Configuration #1, System Configuration #2, Channel Multi-Mode Passive

Models: PA2100

1 15
Download 15 pages 39.25 Kb
Page 10
Image 10

SYSTEM CONFIGURATION #1

Full-Range

Full-Range

Connect Speakers as shown. For best sound,

 

or

always make sure to connect + to + and - to -

 

High-Pass

 

X-OVER

 

MODE

 

HP

LP

 

Full-Range

FULL

Full-Range

or

 

High-Pass

 

2 Channel Full-range -or- High-Pass Mode

This installation is most popular for listeners who want to simply increase the power to the rear speakers in a car. The resulting

performance is most commonly a louder overall sound field from the rear.

But, such a system’s biggest benefit is the additional bass response since the bass control of the radio can be turned up without distorting the amplifier. Such a system is not necessarily louder in the mids and highs but is able to play louder in the low frequencies due to this additional power. This leads to an overall richer and stronger sound experience for the listener without additional subwoofer boxes or electronics that may complicate the system or take up more room. Such a system WILL NOT equal the performance of a subwoofer system but will certainly be a pleasant improvement.

With the addition of a high-pass filter, this amplifier is set up to complement a dedicated subwoofer amplifier/speaker system. This allows for smaller (e.g., 5" or 6") satellite speakers to operate most efficiently without being over-driven in the bass region where a dedicated subwoofer system operates most efficiently.

SYSTEM CONFIGURATION #2

Full-Range

High-Pass

 

X-OVER

MODE

HP

LP

Subwoofer

FULL

High-Pass

Full-Range

3 Channel Multi-Mode (Passive)

The multi-mode system is a “poor-man’s” satellite/subwoofer system. This amplifier is able to drive speakers in stereo mode and at the same time drive low frequencies to a dedicated subwoofer speaker. By inserting inductors (coils) and capacitors, the result is an inexpensive solution to generating a ‘3' channel system with a 2 channel amplifier.

Using passive components (coils and capacitors) the installation

is simple and performs adequately for most listeners. Such a system will not perform as well as an “active” system because the slow attenuation (roll-off) of the frequency response resulting in a moderate amount of over-lapping of the sound spectrum between the satellites and subwoofers. It is important to remember that although surprisingly pleasant performance is achieved, this is a compromise system and will NOT perform as well as a dedicated 3 channel system with electronic crossovers.

8

Page 10
Image 10
Blaupunkt PA2100 manual System Configuration #1, System Configuration #2, Channel Full-range -or- High-Pass Mode