Short instructions
1On 
Off 
Volume 
This unit can also be switched on and off with the Release Panel C.
Also, when being connected correctly, you may turn the radio on and off via the ignition of your car.
Use one of the following possibilities to continue operating the set when the ignition is switched off:
a)Switch on/off with knob 1.
b)
c)Press AUD 3.
When turning on the unit with the re- lease panel or by pressing the AUD button, the system will start to play with the volume adjusted last.
When operating the unit with the igniti- on being switched off, the system will automatically shut down after one hour in order to avoid that the battery goes flat.
2LD
Loudness - When listening at a low level, the Loudness function creates a more natural sound by boosting the low frequency range.
To switch the Loudness on/off: Press LD.
For more information, read chapter “DSC programming”.
3AUD/GEO AUD –
To adjust the treble and bass frequen- cies with the rocker switch.
Treble +
Treble –
Bass –
Bass +
GEO –
To adjust the balance (left/right) and fader (front/rear) with the rocker switch.
Fader front
Fader rear
Balance left
Balance right
To alter a setting,
•press AUD or GEO and then chan- ge the value with the rocker switch.
The adjusted value is indicated in the display.
The last setting will be stored automati- cally.
To finish the setting: Press AUD or GEO.
If the setting remains unchanged within 8 seconds, the display will switch back to the previous condition.
4DSC (Direct Software Control) Use the DSC function to customise certain programmable, basic settings to suit your personal needs and prefe- rences. See chapter “DSC pro- gramming” for more information.
20
