FORLI' Italy
4.0HOW TO USE THE AIR CONDITIONER
4.1STARTING AND FUNCTION SELECTION (fig. 14 and 15)
1)Ambient thermostat.
2)
3)Main switch 0/1.
4)Warm/cold switch (if fitted).
To switch the air conditioner on, push the switch “3” to pos. 1.
4.2 INTERNAL TEMPERATURE ADJUSTMENT
The machine is fitted with an ambient thermostat operated by a blue/red knob. To get the required temperature, it is enough to set the chosen colour to the fixed reference point (pos. A fig. 16). By nearing the knob blue area to the reference point (pos. A fig. 16), the air temperature decreases, provided that switch (pos. 4 fig. 14) is set to "cold".
By nearing the knob red area to the reference point (pos. A fig. 17), the air temperature increases (if fitted), provided that switch (pos. 4 fig. 14) is set to "warm".
IMPORTANTE
The heating function (if fitted) cannot replace the heater of the whole vehicle; it is only designded to warm the ait in cool days.
4.3 AIR CONDITIONER STOPPING
Push the switch “3” to pos. "0" for the unit stop.
DANGER
Never obstruct the air inlets and outlets.
The air conditioner fitted compressor runs during the refrigerating phase of the unit. If switched off and on at once, it might get damaged. Therefore, it is very important TO WAIT ALWAYS 3 MINUTES AT LEAST before attempting to switch it on again.
IMPORTANT
Always use ground plate fitted sockets.
4.4 UNAVOIDABLE DANGERS
CAUTION
Never introduce your hands or other objects within the air inlet openings.
4.5 IMPROPER USE
The air conditioner shall be installed by skilled and authorized technicians only according to the Manufacturer’s instructions.
The air conditioner shall be used only and exclusively for the purposes for which it has been designed and manufactured.
4.6 TROUBLESHOOTING
We have listed below some problems which may occur, along with their respective causes and possible solutions. In the case of problems which are not listed below, please seek advice from an authorised
•Too large vehicle.
•Vehicle walls are not insulated.
•Vehicle with too large windows (in such case, we recommend to use heavy and insulating blinds).
•The vehicle is a camper with a
•Doors are frequently opened.
•Air comes in from the openings.
•Too many people inside the vehicle.
•Voltage less than 230V.
1 The airco does not start.
Causes and Solutions:
1.1No power is supplied.
(Check the electric connection).
2 The airco runs, but the compressor does not start.
Causes and Solutions:
2.1Thermostat with too high temperature. (Lower the thermostat temperature).
2.2The ambient air is less than 18°C. (No solution).
2.3Switch is not set to "cold" position. (Set it to cold).
3 The compressor stops running.
Causes and Solutions:
3.1Low voltage. (Less than 200V).
4
