Blomberg KQD 1360X instruction manual Prior to first use of Water Dispenser

The water filter must be removed as shown in the figure when it is going to be replaced or when it will no longer be used and by-pass cover must be attached. It must be made sure that Ice Off mode is active before taking it out.

A Caution: Water filter cleans some foreign particles in the water. It does not purify water from microorganisms.

A Caution: Ice Off button must always be pressed during replacement of the water filter or installing the by-pass cover.

Prior to first use of Water Dispenser

C Water mains pressure must not be below 1 bar.

C Water mains pressure must not be above 8 bars.

C Pumps must be used in case the supply water pressure drops below 1 bar or if a jug is going to be used.

C Water system of the refrigerator must be connected to the cold water line. It must not be connected to hot water line.

C No water may be obtained in the initial operation of the refrigerator. This is caused by the air in the system. To discharge air from the system, press Dispenser latch for periods of 1 minute until water comes from the Dispenser. Water flow may be irregular in the beginning. Irregular water flow will be normalized after the air in the system is discharged.

C At the initial startup of the refrigerator approx.12 hours must pass before cold water can be obtained.

C Water mains pressure must be between 1-8 bars for the operation of Ice/Water Dispenser smoothly. For this, check that 1 glass of water (100 cc) can be filled in 10 seconds.

C The first 10 glasses of water should not be consumed.

C Approximately the first 30 cubes of ice to be obtained from the Ice Dispenser must not be used.

C Always use the water filter when a jug is not being used.

15

EN