4 - EN
A Ensurethatthecoldandhotwater
connections are made correctly when
installing the product. Otherwise, your
laundry will come out hot at the end of the
washing process and wear out.
2. Tightenallhosenutsbyhand.Neverusea
wrench when tightening the nuts.
3. Open the taps completely after making
the hose connection to check for water
leaksattheconnectionpoints.Ifanyleaks
occur, turn off the tap and remove the nut.
Retighten the nut carefully after checking
the seal. To prevent water leakages and
damagescausedbythem,keepthetaps
closed when the machine is not in use.

Connecting to the drain

• Theendofthedrainhosemustbedirectly
connected to the wastewater drain or to
thewashbasin.
A Yourhousewillbefloodedifthe
hose comes out of its housing during
water discharge. Moreover, there is
risk of scalding due to high washing
temperatures! To prevent such situations
and to ensure smooth water intake and
discharge of the machine, fix the end of
the discharge hose tightly so that it cannot
come out.
• Thehoseshouldbeattachedtoaheightof
at least 40 cm, and 100 cm at most.
• Incasethehose���iselevatedafterlayingit
on the floor level or close to the ground
(lessthan40cmabovetheground),water
dischargebecomesmoredifficultandthe
laundry may come out excessively wet.
Therefore,followtheheightsdescribedin
the figure.
• Topreventflowingofdirtywaterback
into the machine and to allow for easy
discharge, do not immerse the hose end
into the dirty water or drive it in the drain
morethan15cm.Ifitistoolong,cutit
short.
• Theendofthehoseshouldnotbebent,
itshouldnotbesteppedonandthehose
mustnotbepinchedbetweenthedrain
and the machine.
• Ifthelengthofthehoseistooshort,use
itbyaddinganoriginalextensionhose.
Lengthofthehosemaynotbelongerthan
3.2 m. To avoid water leak failures, the
connectionbetweentheextensionhose
andthedrainhoseoftheproductmustbe
fitted well with an appropriate clamp as not
to come off and leak.

Adjusting the feet

A Inordertoensurethattheproduct
operatesmoresilentandvibration-free,it
muststandlevelandbalancedonitsfeet.
Balancethemachinebyadjustingthefeet.
Otherwise, the product may move from
itsplaceandcausecrushingandvibration
problems.
1. Loosenthelocknutsonthefeetbyhand.
2. Adjust the feet until the product stands
levelandbalanced.
3. Tightenalllocknutsagainbyhand.
A Donotuseanytoolstoloosenthelock
nuts. Otherwise, they will get damaged.

Electrical connection

Connecttheproducttoagroundedoutlet
protectedbyafusecomplyingwiththevalues
inthe"Technicalspecifications"table.Our
companyshallnotbeliableforanydamages
that will arise when the product is used
without grounding in accordance with the local