Bloomfield 8742 owner manual Brewer Operation Diagram, A. Start-Up

OPERATION

Fig. 3 Brewer Operation Diagram

IMPORTANT:

Tank must be full of water before pressing TANK HEATER SWITCH "ON". Heating elements will be damaged if allowed to operate without being fully submerged in water. Damage caused by operating the brewer without water in the tank is NOT COVERED BY WARRANTY.

A.START-UP

For initial start-up, or if the brewer has not been used for an extended period of time:

♦Be sure spray disk and brew gasket are properly installed in the brew head.

♦Be sure the water supply is properly connected and the water supply valve is turned ON.

♦Be sure the WATER TANK IS FILLED.

IMPORTANT: Fill the water tank before energizing this unit:

1.Insert the brew chamber (empty) and place an empty dispenser in place under the brew chamber.

2.Be sure the TANK HEATER SWITCH is "OFF". Plug the unit into an appropriate receptacle.

3.Press The BREW switch. Water will start filling the tank. Run several consecutive brew cycles until water flows from the brew chamber.

5.When water stops dripping from the brew chamber, empty the dispenser, then press TANK HEAT switch "ON". The heating element will begin heating water in the tank. When the water has reached the proper brewing temperature, the “READY TO BREW” light will glow.

606 Owners Manual for 8742-8748 Tea Brewer 76116

6