®

Contact 1-800-762-1142 for assistance.

 

Do not return to place of purchase.

 

 

 

 

WARNING

FOR YOUR SAFETY

Do NOT attempt to operate heater until you have read and understand all precautions in Section 1 “Safety First.” Failure to do so can result in serious personal injury, death, or property damage.

If at any time you are unable to light burner and smell gas, wait 5 minutes to allow gas to dissipate before attempting to light heater.

Do NOT touch emitter or dome or move heater for at least 45 minutes after use.

View Hole

Pilot

LOW

(Push in)

 

HIGHOFF

Pilot

LOW

(Push in)

 

HIGHOFF

Operation

Caution: Do NOT attempt to operate heater until you have read and understand all precautions in section 1 “Safety First.”

Before Turning Gas Supply ON

Your heater was designed and approved for OUTDOOR USE ONLY. DO NOT use it inside a building, garage, or any other enclosed area.

Make sure surrounding areas are free of combustible materials, gasoline, and other flammable vapors or liquids.

Ensure that there is no obstruction to air ventilation.

Be sure all gas connections are tight and there are no leaks. Be sure the access panel is clear of debris.

Be sure any component removed during assembly or servicing is replaced and fastened prior to starting.

Before Lighting

Heater should be thoroughly inspected before each use, and by a qualified service person at least annually.

If relighting a hot heater, always wait at least 5 minutes.

Inspect the hose assembly for evidence of excessive abrasion, cuts, or wear. Suspected areas should be leak tested. If the hose leaks, it must be replaced prior to operation. Only use the replacement hose assembly specified by manufacturer.

Lighting

Note: This heater is equipped with a Pilot Light that allows for safer startups and shutdowns. Pilot must be lit before Main Burner can be started.

Push Control Knob IN and turn to OFF.

Wait 5 minutes for any gas to clear.

Open Viewing Hole by sliding cover to either side. Push Control Knob IN and rotate to Pilot position.

Note: For initial start or after re-connecting gas source, hold Control Knob IN for 2 minutes to purge air from gas lines before proceeding.

Push Igniter button once. Pilot Light flame will appear and be visible through Viewing Hole.

Release Control Knob after 30 seconds. Pilot Light will remain lit. If not, return to first bullet point.

Turn Control Knob to ON. Main Burner will light immediately. Flame is visible through Viewing Hole. If not, return to first bullet point.

If you experience any ignition problem consult “Troubleshooting” on page 16.

13

Owner’s manual: model 233010 outdoor patio heater

6/8/04