ASSEMBLY

JACKSHAFT BEARING SUPPORT ASSEMBLY

Attach the Jackshaft bearing support bracket (1) to the tongue. Loosely attach bearing support by using pivot bolt (3) with bushing (6). Install Bearing and housing assembly (4). Install spacers (5) and bolt

(2)leaving installed loosely. Tighten bolt (2) NOTE: Do not tighten to point of collapsing spacer (5). Tighten pivot bolt (3) NOTE: Do not over tighten. Make sure Carrier Bearing (4) pivots in supports and complete assembly pivots on lower bolt. Slide Jackshaft through bearing (4).

NOTE: Install Bearing Assembly with snap ring facing Jackshaft.Bearing should be rigidly attached to jackshaft when shipped. If not apply loctite 609 between shaft and bearing to lock in place.

CV JACKSHAFT SUPPORT ASSEMBLY

Insert the splined end of Jackshaft into the Bearing (6) and attach the Jackshaft Mount (1) to the Tongue with 5/ 8” x 2" bolt (2), flatwasher (3), and locknut (4) as shown in Figure Asm-R-0155. Attach Jackshaft Support (7) to Mount (1) using 5/8” x 1-1/2” bolts (5) and locknut (4). Clamp top and middle section of Support by using 1/ 2” x 7" bolts (10) and locknuts (8), placing Spacers (9) between Supports.

Intensionally Bearing Assembly with snap ring facing Jackshaft. Bearing should be rigidly attached to jackshaft when shipped. If not apply loctite 609 between shaft and bearing to lock in place.

TW120 01/11

Assembly Section 3-9

© 2011 Alamo Group Inc.

ASSEMBLY

Page 105
Image 105
Blue Rhino FC-0025, FC-0024 manual Jackshaft Bearing Support Assembly, CV Jackshaft Support Assembly