Contact | page no. | |
7 | ||
| ||
|
|
Direct Cooking | Cleaning and Care |
1.Light burners per lighting instructions.
2.Set burners to desired level and allow temperature to be reached.
3.Place food directly over burners.
4.With lid open or closed, cook untill desired internal temperatures are acheived.
Indirect Cooking
Ideal for roasts and larger cuts of meat.
1.Remove cooking grid.
2.Place metal tray in center, on heat plates.
3.Replace cooking grid.
4.Light burners.
5.Turn center burner off. Set ouside burners to desired level and allow temperature to be reached.
6.Place food on cooking grid, directly over metal tray.
7.With lid closed, cook until desired internal temperatures are achieved.
Tips For Better Cook Outs and Longer Product Life
1.Spray or coat cooking surfaces with vegetable oil before cooking to avoid sticking.
2.Place vegetables or delicate foods into aluminum foil pouches.
3.Use a quality grill brush after each event to keep cooking surfaces clean and rust free.
4.Empty grease pan after every use.
CAUTION: Do not cover grill until it is completely cool to the touch.
Operating Side Burner
NOTE: Side burner can be used while main burners are operating.
Never use side burner as a grill.
Lighting |
|
|
|
1. Open lid. Attempting to light the |
|
|
|
| Flame |
| |
burner with the lid closed may |
|
| |
cause an explosion! | Burner |
|
|
2. Make sure there are no |
|
| |
|
|
| |
obstructions of airflow to the gas |
|
|
|
unit. Spiders and insects can nest |
|
|
|
within and clog the burner / venturi | 0" | 3/8" | 3/4" |
tube at the orifice. A clogged | |||
burner tube can lead to a fire | 0 mm | 9.5 mm | 19 mm |
|
|
| |
beneath the appliance. | Side burner proper flame height. |
| |
3.Control knob must be in the OFF position.
4.Turn on gas at LP gas tank.
5.Push and turn control knob counterclockwise to HIGH.
6.Press the electronic igniter button and hold for 5 seconds to light burner.
7.If ignition does not occur in 5 seconds, turn burner control knob OFF, wait 5 minutes, and repeat lighting procedure.
8.If igniter does not light burner, use a lit match secured with the lighting rod provided to light burners manually. Position the lit match near side of the burner.
Important: Always use the lighting rod provided when lighting burners with a match.
9.After lighting, please observe the burner flame, make sure all burner ports are lit and flame height matches illustration.
Caution
1.All cleaning and maintenance should be done when grill is cool and with the fuel supply disconnected.
2.DO NOT clean any grill part in a self cleaning oven. The extreme heat will damage the finish.
Notices
1.Abrasive cleaners will damage this product.
2.Never use oven cleaner to clean any part of grill.
3.Do not clean any grill part in a self cleaning oven. The extreme heat will damage the finish.
Cleaning Surfaces
1.Wipe surfaces clean with mild dishwashing detergent or baking soda.
2.For stubborn surfaces use a citrus based degreaser and a nylon scrubbing brush.
3.Rinse clean with water.
Cleaning Main Burner
1.Turn gas off at the control knobs and LP gas tank.
2.Remove cooking grates and heat plates.
3.Remove burner by removing the fasteners securing the burner to the grill bottom.
4.Lift burner up and away from gas valve orifice.
5.Disconnect wire from spark electrode.
6.Clean inlet (venturi) of burner with small bottle brush or compressed air.
7.Remove all food residue and dirt on burner surface.
8.Clean any clogged ports with a stiff wire (such as an opened paper clip)
9.Inspect burner for any damage (cracks or holes). If damage is found, replace with new burner.
10.Reinstall burner, check to insure that gas valve orifice is correctly positioned inside burner inlet (venturi). Also check position of spark electrode.
Cleaning Side Burner
1.Turn gas off at the control knobs and LP gas tank.
2.Remove side burner grid.
3.Remove burner by removing the screws securing the burner to the side shelf.
4.Lift burner up and away from gas valve orifice.
5.Clean inlet (venturi) of burner with small bottle brush or compressed air.
6.Remove all food residue and dirt on burner surface.
7.Clean any clogged ports with a stiff wire (such as an opened paper clip)
8.Inspect burner for any damage (cracks or holes). If damage is found, replace with new burner.
9.Reinstall burner, check to insure that gas valve orifice is correctly positioned inside burner inlet (venturi). Also check position of spark electrode.
CAUTION: If burner flame goes out during operation, immediately turn the gas “OFF” and open lid to let the gas clear for about 5 minutes before
Turning Off
1.Turn control knob clockwise to the OFF position.
2.Turn gas off at LP gas tank.
Cooking
1.Light burner.
2.Set burner to desired temperature
3.Place pan on center of grid.
4.Cook and adjust temperature as needed.