BEFORE USING YOUR HEADSET FOR THE FIRST TIME

-You must charge it continuously for about 8 hours, until the red indicator light turns off. Please refer to the “Charging the BLUETREK® X2” section of this manual.

-Pair the headset with a mobile phone. Please refer to the “Pairing the BLUETREK® X2” section of this manual.

Introduction

The BLUETREK® X2 headset is a wireless headset based on the Bluetooth® technology. It complies with Bluetooth® 1.2 protocol, supporting Headset and Hands- free profile.

The BLUETREK® X2 headset has 3 buttons:

“TALK “button (main button),

1 “VOL+ “button,

1 “VOL- “button.

Charging the BLUETREK® X2

Please connect the charger to the headset and to the mains. During the charge, the indicator light is red. The indicator light will turn off when the charge is complete. During subsequent charges, the charging should take approximately 2 hour 40 minutes.

When you hear a light beep in your headset at regular intervals, and the indicator light flashes in red, your headset needs to be recharged.

Important:

To maximize battery lifetime, it is recommended to recharge your headset to full capacity only when the battery is low, since a battery has a lifetime of about 500 charging cycles.

If you leave your headset battery empty for an extended period of time, it could excessively discharge the battery. In this case, charge your headset for 10 hours or more until the battery recovers and recharges completely. Only switch on the headset once the red indicator light turns off, indicating the battery has fully recovered.

Do not let the battery charger remain plugged in the headset for more than 24h.

The use of any other charger will automatically suspend the warranty.

Pairing the BLUETREK® X2

Before using the BLUETREK® X2 headset, you must pair it with your Bluetooth® mobile phone. Pairing is the process of linking 2 Bluetooth® devices, so that they can communicate.

PAGE 3 / 6

Page 3
Image 3
BlueTrek X2 manual Introduction, Charging the Bluetrek, Pairing the Bluetrek