2Attaching the Mounting Bracket Assembly to a Pole
A)Thread NYLON TIE thru Tie Slots and around pole to TEMPORARILY hold the Mounting Bracket Assembly in place on pole.
B)Insert (4) MOUNTING CHAIN HOOKS
and attached WING NUTS through the most appropriate top & bottom Bracket Assembly slots. 
MOUNTING
BRACKET
ASSEMBLY
SLOTS
POLE
MOUNTING
HOOKS
& WING NUTS
MOUNTING
BRACKET
ASSEMBLY
MOUNTING
HOOKS
& WING NUTS
NYLON
TIE
TIE SLOT
MOUNTING
HOOKS
& WING NUTS
MOUNTING
BRACKET
ASSEMBLY
MOUNTING
HOOKS
& WING NUTS
TOP
POLE CHAIN
NYLON
TIE
BOTTOM
CHAIN
C)With Hooks fully extended, attach one end of MOUNTING CHAIN to one of the Top Mounting Hooks.
Pull the Chain tight to Pole and then attach shortest link to corresponding Top Hook. (To keep chain from being jammed by the hook, place link on outside of the Hook.) Spin Wing Nuts down evenly, enough to keep the Assembly in place.
D)Repeat process for Bottom Hooks and Chains.
E)Hand tighten all Wing Nuts evenly, ensuring Mounting Bracket Assembly is difficult to rotate on the Pole. Then “tap” the chain sharply to remove any slack and fully
IMPORTANT: HAND TIGHTEN ONLY. EXCESS TIGHTENING MAY CAUSE HOOK ENDS TO SPREAD.
