Bogen TMA812 specifications Pole Mount TOP-DOWN View, Wall Mount TOP-DOWN View

HEX SOCKET

SAFETY BOLT LOCK WASHER (Included with Speaker) (Included with Mount)

6Speaker Safety Cable and Tether Link Attachment Installation

A)Find the SAFETY ATTACHMENT POINT located on the rear of the A8/A12 Speaker. Using the (1/4”- 20 x 1/2”) HEX SOCKET SAFETY BOLT and the LOCK WASHER, secure the SAFETY TETHER LINK into the Safety Attachment Point, vertically,

as shown.

B)POLE MOUNT (TOP-DOWN VIEW)

SAFETY

TETHER LINK

SAFETY ATTACHMENT POINT

SPEAKER MOUNTING BRACKET

A8/A12

LOUDSPEAKER

POLE

SAFETY

TETHER LINK

8 FT. SAFETY CABLE	ADJUSTABLE
	WIRE CLAMP

WHEN INSTALLATION IS FINISHED, THE SAFETY CABLE SHOULD BE TAUT. CABLE SLACK SHOWN IN DRAWING IS FOR ILLUS- TRATIVE PURPOSES ONLY.

Take the 8 FT. SAFETY CABLE and loop it tightly around the Pole/Post 2-3 times. Proceed to feed one end of the Safety Cable in through the Speaker Mounting Bracket, then into the open hole of the Safety Tether Link. Pull the Cable taut, leaving very little slack, and secure the two Cable ends using the ADJUSTABLE WIRE CLAMP.

C) WALL MOUNT (TOP-DOWN VIEW)

Take the 8 FT. SAFETY CABLE and feed it through the Tie Slots (see figure A in Section 2 for Tie Slot location) of the mounted Stationary Mounting Bracket, then into the open hole of of the Safety Tether Link. Pull the Cable taut, leaving very little slack, and secure the Cable ends using the ADJUSTABLE WIRE CLAMP.

WHEN INSTALLATION IS FINISHED, THE SAFETY CABLE SHOULD BE TAUT. CABLE SLACK SHOWN IN DRAWING IS FOR ILLUSTRATIVE PURPOSES ONLY.

WALL

8 FT.	SPEAKER
SAFETY	MOUNTING
CABLE	BRACKET

A8/A12

LOUDSPEAKER

TIE SAFETY

SLOT TETHER LINK

ADJUSTABLE

WIRE CLAMP