CONTENTS OF HARDWARE PACK
Parts bag contents (not shown full size)
(1) Border/Edger Wheel
(2) Bushings for Narrow Width Tilling
(1)Short Bushing for Border/Edger
Parts packed separately in carton (not shown full size)
(1) Border/Edger Tine
ASSEMBLY
Read these instructions in their entirety before you attempt to assemble or operate your new equipment.
The Border Edger Attachment does not need to be installed until you are ready to do edging projects (refer to instructions in this Section).
To ensure safe and proper operation of your machine, all parts and hardware you install or adjust must be tightened securely. Use the correct tools to ensure proper tightness.
IMPORTANT: The correct mixture of unleaded automotive gaso- line and
UNPACKING INSTRUCTIONS
•Inspect your machine immediately. If you find or suspect damage to the carton or contents, contact your local autho- rized dealer or the Factory for assistance.
•Remove any packing material. Check for small parts before discarding the packing material or carton.
•Perform the assembly on a clean, level surface. Be careful not to severely bend any of the control cables on the unit.
•Before starting any assembly steps, disconnect the engine spark plug wire from the spark plug.
TOOLS NEEDED FOR ASSEMBLY: An adjustable wrench and a
ASSEMBLY STEPS
STEP 1: Unfold and Adjust Handlebars
IMPORTANT: Be careful not to pinch any wires or cables while unfolding and adjusting the handlebars.
•Loosen the two handlebar knobs (A, Figure 1) and unfold the handlebars into the operating position. Do not use force — if there is binding, continue to loosen the knobs.
•There are two height settings holes in the upper handlebar. The unit is shipped with the handlebar knobs in the lowest
6