
Attaching The Chute Deflector
3.a. Remove the wing knobs from each side of the lower impeller housing.
b.Remove the hex lock nut, spacers, and hex bolt from the top of the impeller housing. See Figure
4.a. Align the chute deflector in position on the discharge opening and insert hex bolt with spacer through hinge on chute deflector (spacers fit inside of hinges). See Figure
b.Place second spacer over hex bolt inside other hinge and secure with hex lock nut.
c.Secure both sides of chute deflector to impeller housing using wing knobs previously removed.
Attaching The Chipper Chute
(Model Series 460)
B
A
C
3
Setting Up
Your Chipper
Shredder
5. a. Remove the three cupped washers and hex nuts |
|
| |
from weld studs around the opening on the side of | Figure | IMPORTANT | |
the impeller housing. See Figure |
| This unit is shipped | |
b. Remove the hex bolts, flat washers, and lock nuts |
| ||
| without gasoline or | ||
from the two holes on the upper end of the support |
| ||
| oil in the engine. Be | ||
brace. |
| ||
6. a. Align the chipper chute over the weld studs, so the |
| certain to service | |
slot in the bottom of the chute is facing down. | B | engine with gasoline | |
b. Secure chipper chute with the three cupped | and oil as instructed | ||
washers (cupped side against the chipper chute) |
| in the separate engine | |
and hex nuts previously removed. Do not tighten |
| ||
| manual before operat- | ||
the nuts at this time. See Figure |
| ||
A | ing your machine. | ||
| |||
|
| NOTE: All references | |
|
| in this manual to the | |
|
| left or right side of | |
|
| the chipper shredder | |
|
| is from the operating | |
| Fgure | position only. Excep- | |
| tions, if any, will be | ||
|
| ||
|
| specified. | |
|
| NOTE: This Operators | |
|
| Manual covers a range | |
|
| of product specifica- | |
|
| tions for various | |
|
| models. Characteristics | |
|
| and features discussed | |
|
| and/or illustrated in this | |
| A | manual may not be ap- | |
| plicable to all models. | ||
| B | MTD LLC reserves the | |
|
| right to change product | |
|
| specifications, designs | |
|
| and equipment without | |
| Figure | notice and without | |
| incurring obligation. | ||
|
|